"wiremold"

Steel, 19.5" Pre-Cut Cover, 4000 Series. Size: 4-3/4" Width. Ivory.

Category: Large 2-Piece Metallic Raceway Covers

Steel, Supporting Clip, 2000 Series. Size: 2". Ivory.

Category: Small 2-Piece Metallic Raceway Clips, Connectors, & Couplings

Single-service fitting includes housing, base, two mounting frames, and mounting hardware. For use on 2" (51mm) IPS or PK Preset Systems. For PK activation, use in conjunction with FloorPort Partition Feed and PK Kit. Has 1/2" and 3/4" trade size conduit knockouts on each end. 53.3 cu. in. (906cm3) capacity.

Category: Recessed Floor Box Service Fittings

Poke-Thru Device, Flush, Assembled Unit, Non-Metallic Cover, Color: Black with Brass Flange. Diameter: 8-1/4". Depth: 9-1/16". Includes: Duplex Receptacle (20 Amp, 125 Volt, NEMA 5-20R, 2P, 3W, Straight Blade), (1) Ortronics TracJack Mounting Bezel & (1) Ortronics Series II Communication Housing (Devices Sold Separately). For use with Carpet or Tile Applications.

Category: Assembled Poke-Through Units

Steel, Special Nipple, 500, 700 Series. Thread: Female 3/8" Inside, Male 1/2" Outside. Galvanized.

Category: Metallic Raceway Connectors & Adapters

Internal GFI Decorator Bracket, Accepts Standard GFCI Receptacles

Category: Recessed Floor Box Service Fittings

WMD 8CREST3G 3 GANG CRESTRON

Category: Poke-Through Mounting Plates

Steel, Adjust-to-Fit® Coupling, DS4000 Series. Size: 6" Length. Galvanized. Sold in Pairs.

Category: Large 2-Piece Metallic Raceway Clips, Connectors, & Couplings

Tele-Power Pole, Blank, Steel, Vertical, 1 Compartment, NO OUTLETS, Ivory.

Category: Steel Power Poles

SURFACE WALL DUCT COVER

Category: 2-Piece Non-Metallic Raceway

Accepts two (2) Wiremold CM Series Open System adapters (sold separately). NOTE: For use with RFB4E, RFB6, RFB6E Series Floor Boxes.

Category: Recessed Floor Box Service Fittings

Unit includes four prewired 20A receptacles. Each duplex receptacle is wired as separate circuit. The duplex can be wired as a standard receptacle or isolated ground. Finish flange available in gray (GY), black (BK), ivory (VY) or brushed metal finishes in aluminum (AL), and brass (BS). Aluminum and brass flanges shipped with black slide cover. Brass flange also available with nonmetallic brass colored slide holder (AB). Aluminum flange also available with nonmetallic aluminum colored slide holder (AA). Includes Wiremold Open System unloaded adapters to accept four discrete keystone connectors from most manufacturers. Unit also includes Ortronics TracJack Mounting adapters and Ortronics Series II Communication Housing. Modular jacks sold separately. NOTE: Assembled with scrub water gasket. For use on tile or carpet floors. RC4 Series Poke-Thru Devices require a 4 (102mm) diameter hole. Not designed to work with bare concrete or terrazzo. Floor covering thickness 1/8 minimum. RC4 Assembled Unit-Aluminum Finish Flange Black Slide Holder, 2-20A Duplex Standard or IG and Cat 6 Connectors.

Category: Assembled Poke-Through Units

6IN PRWRD FLUSH BRONZE ASSEMBLY

Category: Assembled Poke-Through Units

Combination Carpet and Tile Flange, 3-Gang, Powder-Coated Aluminum, Nickel

Category: Square / Rectangle Recessed Box Flanges

Available in standard width. Provided with bezel to accept up to three (3) dual Wiremold CM Series Open System communication modules or Pass and Seymour Activate Connectivity System inserts. Modules and inserts sold separately.

Category: 1-Gang Raceway Device Brackets & Plates

Cover Plate Flange, 1-Gang, Non-Metallic, Brown. W x L: 4-3/4 x 5-3/4 Inch. For use with: 829PFLRT, 829PFL Covers and Accepts MAB6TJ, MAB3S2, CM-MAB and CM Series Inserts in Carpet and Tile Applications.

Category: Square / Rectangle Recessed Box Flanges

2-GANG ALUM TILE FLANGE

Category: Square / Rectangle Recessed Box Flanges

Two Gang Device Box. Cover has twistouts for 2000, 500 and 700 Series Raceways. Base has 1/2" trade size KO and rectangular KO for extension to wall box. Base has #10 threaded hole for ground connection. Finish - Gray

Category: 2-Gang Raceway Switch & Receptacle Boxes

4 Inch Pre-Pour Poke-Thru Sleeve, Nonmetallic Sleeve Attaches to Structural Steel or Plywood Decking, Unit Includes (3) Attachment legs, (2) End Caps and (3) Thumb Screws

Category: Assembled Poke-Through Units

1-GANG CARPET & TILE FLANGE BZ

Category: Square / Rectangle Recessed Box Flanges

Conversion Kit, Includes: 825A (1/2") , 825C, 825L, 825N, For Carpet or Tile installations

Category: Round Recessed Box Covers

Communication Bracket. Includes: (4) RJ Keystone Opening Knockouts. Opening Size: 9/16"x3/4". For use with: RFB4 Series Compartment Type Boxes.

Category: Recessed Floor Box Service Fittings

Non-Metallic, Drop Ceiling Connector, 2700 Series. Size: 2-1/8" Length, 1-7/16" Width. PVC, Ivory.

Category: 1-Piece Non-Metallic Raceway Connectors & Adapters

2000 Raceway Base & Cover Black û Base û 2000B .040" (1.0mm) steel. Cover û 2000C .025" (.6mm) steel. Supplied with two (2) 2010B Blank End Fittings and (1) 2001 Base Coupling. *Ordered in 5 ft internals. order 5 to get 1 base and cover*

Category: Non-Metallic Overfloor Raceway