Poke-Through Systems

Center-gang 2" trade size conduit service feed assembly. Designed to allow connection to 2" trade size conduit feed in two (2) of the four (4) center- gang locations.

Category: Assembled Poke-Through Units

Hubbell Wiring Device Kellems, In-Floor Delivery Systems, Fire RatedPoke Throughs, SystemOne, 6" Series, 2) 20A 125V Receptacles, 2)Decorator Openings, Black

Category: Assembled Poke-Through Units

Includes insert stem with disposable plate and two-gang service head with housing, base, scrub water gasket, and barrier. Service head and insert install together to make a poke-thru assembly. Combine with faceplates (sold separately) to complete service head assembly. Shown assembled. Service head is shipped unassembled with the insert stem. NOTE: Assembled with scrub water gasket. For use on tile or carpet floors. Requires a minimum 3 1/16" (78mm) diameter hole.

Category: Assembled Poke-Through Units

Poke-Thru, Tamper-Resistant, Flush Style Cover Assembly, Diameter: 7-1/4 Inch Round, Gray

Category: Poke-Through Cover Assemblies

For 881 PVC Floor Box for furniture feed applications. Includes one (1) 3/4" trade size conduit opening and one (1) 1 1/4" trade size conduit opening. Provided with one (1) 3/4" trade size conduit connector and one (1) 1 1/4" trade size conduit connector. CAUTION: Not for use on concrete pours less than 4 1/2" (114mm). Not for use when concrete is the finished floor. Use only for tile, carpet and wood covered floors. NOTE: For carpet or tile installations. All cover plates are furnished with gasket and three screws. The 895P Polycarbonate Series Cover Plates must be field modified for dual service. Finish - Black

Category: Poke-Through Cover Assemblies

Kellems Wire Management, Liquidtight System, 45 Degree Male Liquid Tight Connector, 1/2", Steel, Insulated

Category: Assembled Poke-Through Units

WMD RC7AM2TCAL 2IN. FURNITURE

Category: Assembled Poke-Through Units

WMD PSRC9TCBS

Category: Assembled Poke-Through Units

A/V device includes one prewired 20A duplex receptacle which can be wired as a standard receptacle or isolated ground. Finished with an brushed aluminum flange and a black colored device plate. Includes one adpater to accept Legrand AVIP or Extron Electronics MAAP mini architectural adapter plates, Wiremold Open System adapters, and Ortronics TracJack and Series II mounting adapters. Modular Jacks sold separately. NOTE: Assembled with scrub water gasket. For use on tile or carpet floors. AV3 Series Poke-Thru Devices require a 4" (102mm) diameter hole. Not designed to work with bare concrete or terrazzo. Floor covering thickness 1/8" minimum. Finish - Anodized Aluminum

Category: Assembled Poke-Through Units

WMD 10PPS 10IN PREPOUR SLEEVE

Category: Assembled Poke-Through Units

Poke-Thru, Tamper-Resistant, Surface Style Cover Assembly, Diameter: 7-1/4 Inch Round, Black

Category: Poke-Through Cover Assemblies

In-floor Delivery Systems, Systemone Through-floor Fitting, 4x4, Dual Channel

Category: Assembled Poke-Through Units

Nonmetallic slide holder assembly. Available in black (BK), gray (GY), ivory (VY), nonmetallic brass (BS), and nonmetallic aluminum (AA). Assembled with scrub water gasket. For use on tile or carpet floors.

Category: Poke-Through Cover Assemblies

Poke-Thru, Tamper-Resistant, Flush Style Cover Assembly, Diameter: 7-1/4 Inch Round, Bronze

Category: Poke-Through Cover Assemblies

Includes 6" diameter poke-thru stem assembly with a disposable plate. Devices are recessed 3 1/4" (83mm) below floor surface. No cover assembly is included. For use with the following cover assemblies (purchased separately): 6CTC and 6CT Series. INCLUDED: For Side Compartments: Two (2) proprietary 20A Duplex Power Receptacles installed. For Center Compartment: One (1) 6ACT8A Mounting Plate, One (1) 6TRAC Mounting Plate, One (1) 6SER Mounting Plate. For Bottom Feed Compartment: One (1) 5BLH 1/2-Gang Pass-Through Blank Housing Assembly (Tunneling extends from the 5BLH to 575CHA so that power cables from the 20A duplex receptacle mounted on the left side of the poke-thru device are run into the junction box attached to the 575CHA.) , One (1) 1PTHA 1-Gang Pass-Through Housing Assembly, One (1) 575CHA 1/2-Gang 3/4" Conduit Housing Assembly (also includes junction box attached to the 3/4" conduit). NOTE: UL Fire Classified for up to 2-hour rated floors. Receptacles can be wired as a standard or isolated ground device.

Category: Assembled Poke-Through Units

Nonmetallic slide holder assembly. Available in black (BK), gray (GY), ivory (VY), nonmetallic brass (BS), and nonmetallic aluminum (AA). Assembled with scrub water gasket. For use on tile or carpet floors. Black

Category: Poke-Through Cover Assemblies

Hubbell Wiring Device Kellems, In-Floor Delivery Systems, Fire RatedPoke Throughs, SystemOne, 6" Series, Sub Plate, 50/50 Split, Left Side,3 xAAP

Category: Poke-Through Mounting Plates

Poke-Thru, Flush Style Cover Assembly, Diameter: 7-1/4 Inch Round, Bronze

Category: Poke-Through Cover Assemblies

Available in black (BK), gray (GY), ivory (VY), nonmetallic brass (BS), and nonmetallic aluminum (AA). Assembled with scrub water gasket. For use on tile or carpet floors.

Category: Poke-Through Cover Assemblies

Available in black (BK), gray (GY), ivory (VY), nonmetallic brass (BS), and nonmetallic aluminum (AA). Assembled with scrub water gasket. For use on tile or carpet floors. Brass

Category: Poke-Through Cover Assemblies

THB FPT445-SW-BLK BASE W/MOPT

Category: Assembled Poke-Through Units

S1R 4 FITTING QUAD NICKEL COVER

Category: Assembled Poke-Through Units

WMD 8AT2PSN 8IN PREWIRED FLUS

Category: Assembled Poke-Through Units

WMD 4ATP4RSN

Category: Assembled Poke-Through Units