Search results

Contactor, 52 Amp, AC3 Duty, 100- 250 Volt AC/DC Electronic Coil, Screw Terminals

Category: IEC Contactors - 38-65 Amp

Safety Contactor, IEC, 100S, 52 Amp, AC3 Duty, 24 - 60 Volt AC 50/60Hz / 20 - 60 Volt DC Electronic Coil, No Standard Contacts & 2 Normally Open 2 Normally Closed, Lower Power Auxiliary Contacts

Category: IEC Contactors - 38-65 Amp

AB 1370-LG52 CONTACTOR CRIMP LUG

Category: Starter & Contactors - Terminal Lug Kits

Contactor, 52 Amp, AC3 Duty, 100- 250 Volt AC/DC Electronic Coil, Screw Terminals

Category: IEC Contactors - 38-65 Amp

Softstarter PSTX30-690-70 has a rated maximum operational current of 30 A with an operating voltage span from 208...690 V AC. The rated control voltage is between 100...250 V AC at 50/60 Hz. PSTX features a three-phase control soft start and stop through a voltage or a torque ramp. It has built-in bypass for easy installation and energy saving. A RUN, TOR and Event signal is available from relay outputs in NO (normally open state). The PSTX has functions such as current limit, kickstart, analog output, EOL, motor heating and pump cleaning. PSTX also features features jog, braking, stand-still brake, diagnostics, sequence start and emergency/fire pump mode as standard

Category: Advanced Control Softstarters

3 pole thermal overload relay with 36-52 amperes setting range. Rated insulation voltage 690V.

Category: Overload Relays - Thermal Type

Safety Contactor,IEC,52 Amp, AC3 Duty, 100 - 250 Volt AC/DC, Electronic Coil, 3 Normally Open Power Poles, No Auxiliary Contacts,2 Normally Open, 2 Normally Closed, Safety Auxiliary Contacts, Lower Power, Screw Terminals

Category: IEC Contactors - 38-65 Amp

S611 Series Solid-State Soft Starter. Control Voltage: 120V AC. Load Voltage: 600V AC, 52 Amp, 26 - 52 FLA (Full Load Amps), Non-Combination, Standard Duty, 300% Current or 15 Seconds, 115% Continuous. Hp Ratings: 15 @ 208V, 15 @ 240V, 40 @ 480V, 50 @ 600V. Includes: Overload Protection, Bypass, Serial Modbus Communication. ***Must add (2) Lug Kits***

Category: Basic Control Softstarters

Starter, Combination, 70 Amp, Breaker, 52 Full Load Amp, S611, NEMA 3R, 480 Volt AC

Category: Pump Panel Softstarters

Safety Contactor,IEC,52 Amp, AC3 Duty, 24 - 60 Volt AC, 20 - 60 Volt DC, Electronic Coil, 3 Normally Open Power Poles, No Auxiliary Contacts 4 Normally Closed, Safety Auxiliary Contacts, Lower Power, Screw Terminals

Category: IEC Contactors - 38-65 Amp

C-H S611A052P3S REDUCED VOLTA

Category: Basic Control Softstarters