Heating & Ventilation

BRO 629 STEEL HOUSING, STEEL

Category: Medicine Cabinets

Timer, 15-Minute With Separate On/Off Control, On/Off Portion Can Be Used To Control A Separate Light, Vent Or Heater, Works With Any NuTone Heater Or Ventilator.

Category: Multi-Function Fan Controls

Motor & Grille Assembly, CFM: 70, Sones: 3.0, Duct Size: 3", Compatible with: Broan 671R - 90CFM. Has Been Replaced By Nutone AN110F

Category: Fan Motor / Grill Assemblies

Ceiling Fan with Light, CFM: 110, Sones: 1.3, Duct Size: 4", 36W Max Bulb (Incandescent), 4W Nightlight, Energy Star Qualified, Color: White, Includes: (2) 18W Incandescent Bulbs. Has Been Replaced By Broan AE110L

Category: Fan / Light Units

Broan® Heater, 750/1500W 120VAC, 1125W 208VAC, 1500W 240VAC

Category: All Area Fan Forced Heaters

Fan Control, Rotary Dial, 3-Speed, 1-Pole, 1.5A, 120V, Color: Ivory. For use with all: Broan Ceiling Paddle Fans.

Category: Paddle Fan Rotary Controls

Ceiling Fan, CFM: 50, Sones: 0.3, Duct Size: 6", Energy Star Qualified, Color: White.

Category: Ceiling Fans

1500 CFM Exterior Blower for Broan Elite Range Hood, 4.3 Amp, 120 Volt

Category: Range Hood Accessories

10 Inch Round Duct for Range Hoods and Bath Ventilation Fans

Category: Semi-Rigid Duct

Surface Mount Collar For Ironing Centers.

Category: Ironing Center Cover Pads

Ironing Center, Flat Panel Door, HxWxD: 50" x 16" x 1", Finish: Unfinished Birch.

Category: Ironing Center Doors

Grill Replacement With Springs For Broan: 676, 684. Nutone: 684NT.

Category: Replacement Fan Accessories

Ceiling Hat Bracket. Compatible with: Cadet CEH Series Industrial Unit Heaters. *Cadet Part # 09660*

Category: Heater Mounting Brackets

4" Finish Pack, CFM: 50, Sones: 0.5, Energy Star Qualified, Series: InVent. For Use With Broan A000HF Fan Housing Packs To Complete The Installation. Includes: Fan Motor and White Grille. Housing L x W x D: 9-1/4" x 10" x 5-3/4".Grille Size: 11-3/8"L X 12"W.

Category: Fan Housing / Finish Packs

SUP C739H-1 B HVY WELD STL BR

Category: Brackets

Adjustable High Speed 80/110 CFM, Adjustable Low Speed 0-80 CFM, Dual Speed Exhaust Fan/Dimmable 13-Watt LED Light & 2-Watt LED Nightlight w/Motion and Adjustable Humidity Sensor, 9.7 Watt, <0.3 sones, ENERGY STAR®-Qualified, Ceiling Mount, 6 Inch Duct, Includes 6 Inch to 4 Inch Reducer

Category: Fan / Light Units

Used to support the 24x4 system from new threaded rod installations. Bracket is secured to threaded rod with two nuts. The pre-assembled slide clamps enable fast assembly to channel. Use 7/16" nut driver on slide clamps.

Category: Brackets

Used to support the 6x4 and 4x4 systems by spanning two threaded rod drops. Can be installed from above or below. Bracket is secured to each threaded rod with two nuts. The pre-assembled slide clamp enables fast assembly to channel. Use 7/16in nut driver

Category: Brackets

Used to support the 6x4 and 4x4 systems by attaching to underfloor pedestals. (Contains all necessary hardware.) Use on pedestals up to 1" in diameter. The pre-assembled slide clamps enable fast assembly to channel. Use 7/16" nut driver on slide clamps.

Category: Brackets

Used to support the 12x4 system by spanning two threaded rod drops that are 18in apart. Can be installed from above or below. Bracket is secured to each threaded rod with two nuts. The pre-assembled slide clamps enable fast assembly to channel. Use 7/16in

Category: Brackets

Net-Contain™Vertical Exhaust Duct (VED) for 600mm Wide Net-Access™ Cabinet, height adjustable from 26.0" 660(mm) up to 38.0" (965mm). Color: White

Category: Central Vacuum Exhaust Vents

The Net-Direct™ Air Inlet Duct provides cold airflow directly into Cisco MDS 9506 switch intakes from above, below and the side. Not only does it require no energy to operate, but it also reduces fan power consumption by up to 250W, improving energy effic

Category: Central Vacuum Exhaust Vents

Used to support the 24x4 system by spanning two 1/2" existing threaded rod drops. Can be installed from above or below. Bracket is secured to each threaded rod with two split nuts. The pre-assembled slide clamps enable fast assembly to channel. Use 7/16"

Category: Brackets

Used to support the 12x4 system by attaching to underfloor pedestals. (Contains all necessary hardware.) Use on pedestals up to 2" in diameter. The pre-assembled slide clamps enable fast assembly to channel. Use 7/16" nut driver on slide clamps.

Category: Brackets