Search results

Servo Motor, Rotary, 460 Volt, 5000 RPM, Low Inertia, 100 mm Frame Size, 24 Volt DC Brake, SpeedTEC DIN Connector

Category: 480 VAC Servo Motors

Locking Switch, GuardMaster, Solenoid, 24 Volt AC/DC, Contacts(Safety and Aux) 2 x PNP (0.2 Amp maximum), 1 x PNP (0.2 Amp maximum), Door Proximity, Actuator-Fully-Flex, Connector 8-Pin Micro (M12)

Category: Safety Interlocks

Contactor, IEC, 40 Amp, 4-Pole, 120 Volt AC Coil, 4 Normally Open, 0 Normally Closed, Main Contacts

Category: IEC Contactors - 4-Pole

Legend Plate, White, Blank, 30mm, Standard Size, Engravable

Category: 30mm Pushbutton Legend Plates

Terminal Block, 10 Amp, 5 - 30 Volt AC/DC, Plug-In Distribution, Internally Jumpered, Blue, 26 - 14 AWG, 1.5 mm, 100 in a Package

Category: Three Level Sensor Terminal Blocks

Kinetix 5300 Servo Drive, 3.13 kW @ 230 Volt AC (3-Phase), 2.02 kW @ 230 Volt AC (1-Phase), 0.97 kW @ 110 Volt AC (1-Phase)

Category: 240 VAC Servo Drives

Receptacles, Power, ArmorStart, 4 Pin, Female, 32 Amp, 10 Awg, 600 Volt AC, 3 meter, Color Code B

Category: VFD Power Receptacles

Motor Controller, SMC-3, Open Type, 135 Amp, 480 Volt, 3 Phase, 100 - 240 Volt AC Coil

Category: Basic Control Softstarters

Contactor, IEC, 40 Amp, 4-Pole, 24 Volt DC, Electronic Coil w/Integrated Diode, 4 Normally Open, 0 Normally Closed, Main Contacts

Category: IEC Contactors - DC Operating

Servo Motors, VPL Low Inertia, 480 Volt AC, 115 mm Bolt Circle, Frame Size, 3 (Three) Magnet Stacks, F Winding, 4500 RPM Rated Speed, 18 bit Single-Turn, Digital High Resolution Encoder, Keyed Shaft, SpeedTec Right Angle DIN Connector, 325° Rotatable, No Holding Brake

Category: 480 VAC Servo Motors

Ethernet/IP Encoder - CIP Motion, Multi-Turn (4096 Turns), Solid Shaft 10 mm, M12 Connector, 262,144 (18 bit) Steps per Revolution

Category: Shaft Encoders

Terminal Blocks, 6.1 mm, (AWG 26 - AWG 10) , 30 Amp, 600 Volt AC/DC, Feed-Through, Single Level, 1 Point On One Side, 2 Points On Other Side, Gray, 100 per Pack

Category: 4mm Feed Through & Ground Terminal Blocks

Terminal Block, Jumper, Screwless Center, 8 Pole, Yellow, for 1492-L3, L3T, L3Q, L3P, LD3, LD3C, LKD3, LTF3, LS2, L16D, 20 in a Package

Category: Terminal Block Jumper Bars

Drive, PowerFlex 525, 525 - 600 Volt AC, 0.75 kW, 1 Horse Power, 1.7 Amp, Normal & Heavy Duty, Frame A, No Filter

Category: 600 Volt AC Operated General Purpose Variable Frequency Drives

Terminal Block, Jumper, Screw Type Center, 3 Pole, Gray, for 1492-W4, W4TW, 10 in a Package

Category: Terminal Block Jumper Bars

Boot, Protected, Yellow, Chlorosulfonated Polyethylene, For Non-Illuminated 30 mm Push Buttons

Category: Pilot Device Pushbutton Boots

Terminal Block, Jumper, Screw Type Center, 10 Pole, Gray, for 1492-WM4, 10 in a Package

Category: Terminal Block Jumper Bars

Drive, PowerFlex 523, 380 - 480 Volt AC, 11 kW, 15 Horse Power, 30 Amp, Normal & Heavy Duty, Frame D, with Integral EMC Filter

Category: 480 Volt AC Operated General Purpose Variable Frequency Drives

Undervoltage Release Module, 120 Volt AC, 140MT, Left Side Mount, 18mm Width, Automatically Trips MPCB/MCP When Voltage Falls Below 35…70%

Category: Manual Motor Protector Undervoltage Releases

Relay, Safety, Control, 10 Amp, 24 Volt DC, Coil, 12 Pole, 10 Normally Open, 2 Normally Closed Contacts, Open DIN Rail Mount

Category: Intelligent Safety Relays

Motor Circuit Protector, Standard Magnetic Trip (Fixed at 14 x le), 16 Amp, High Performance, Frame Size D, Rotary Style

Category: Manual Rotary Motor Controllers

Switch, Cable Pull, Lifeline Tensioner, Allen Key Only

Category: Control Station Accessories

Communications Adapter, PowerFlex, Architecture Adapter for ControlNet to DPI Communication

Category: Variable Frequency Drive Communication Adapters

Circuit Breaker -Current Limiting D-Frame, 2 Pole, Rated Current 5 A

Category: Manual Rotary Motor Controllers