Search results

Terminal Block, Jumper, Screwless Center, 10-Pole, Red, for 1492-LM2, LC3, LDC3, LDAG3, LDG3P, 10 in a Package

Category: Terminal Block Jumper Bars

Terminal Block, Side-by-Side, 2 Circuit, 25 Amp, 600 Volt AC/DC, 5.1 mm, Gray, 50 per Pack

Category: 5.2mm Feed Through & Ground Terminal Blocks

Busbar Cover, 1-Pole, 1 meter Length, Snap-on, 12…30 mm Height x 5 mm Width

Category: Modular Motor Control Busbar Covers

Terminal Block, Screw Type Center Jumper, 10 Pole, Gray, for 1492-WM3, 10 in a Package

Category: Terminal Block Jumper Bars

Contactor, IEC, 37 Amp, 3-Pole, 24 Volt DC Electronic Coil, Integrated Diode, 1 Normally Closed, Auxiliary Contact, Load Side Coil Termination

Category: IEC Contactors - DC Operating

Terminal Block, 25 Amp, 600 Volt AC/DC, 2 Connections Point per Side, Orange, 30 - 12 AWG, 2.5mm, 50 in a Package

Category: 5.2mm Feed Through & Ground Terminal Blocks

Terminal Block, Screw Type Center Jumper, 4 Pole, Gray, for 1492-W16S, 10 in a Package

Category: Terminal Block Jumper Bars

Busbar, Terminal Shroud, 25 Amp, Spacing Adapter, for 141A-FS, FM

Category: Modular Motor Control Terminal Covers

3 Phase Power Media Trunk Power Cable, Non-Shielded, M35, 10 AWG, Straight Female, 6 M, 4 Pin

Category: VFD Control Panel Cables

PowerFlex 753 AC Drive, With Embedded I/O, Standard Protection, Forced Air, AC Input with DC Terminals, Flange Type, 34 Amp, 25 Horse Power Normal Duty, 20 Horse Power Heavy Duty, 480 Volt AC, 3-Phase, Frame 3, Filtered, CM jumper Installed (Preferred), DB Transistor, Blank (No HIM)

Category: 480 Volt AC Operated General Purpose Variable Frequency Drives

Terminal Block, 85 Amp, 600 Volt AC/DC, Red, 16 mm, Feed Through, 50 in a Package

Category: 16mm Feed Through & Ground Terminal Blocks

Terminal Block, High Density, 55 Amp, 600 Volt AC/DC, Red, Finger Safe, Single Circuit, 50 in a Package

Category: 10mm Feed Through & Ground Terminal Blocks

Motor Controller, SMC-3, Open Type, 27 - 108 Amp, 200/208, 230, 380/400/415/460, Volt, 3 Phase, 24 Volt AC/DC Coil, 20 - 75 Horse Power

Category: Basic Control Softstarters

Terminal Block, End Barrier, Spring Clamp Style, Blue, 0.08 x 2.05 x 2.99 Inch, for 1492-LD4, LD4C, LDG4, LDG4C, LD4DF,LD4DR, LD4RB, LD4SS, 20 in a Package

Category: Terminal Block End Sections

Spring Clamp Terminal Block, One-Circuit Feed-Through, 4 mm Or 2.5 mm, 2 Connections, Green

Category: 4mm Feed Through & Ground Terminal Blocks

Terminal Block Accessory, Center Jumper, IEC, Orange, 4 Pole, For 2.5 mm Terminal Blocks

Category: Terminal Block Jumper Bars

Cable, Pre-wired, for 1756-OF8 (Current), or 1756-OF8H (Current/Hart), Analog Output Module, 22AWG, 9 Twisted Pair Conductor, Shielded, with 1756-TBNH Connector, and AIFM 25-Pin, D-Shell Connector, 2.0 meter, (6.56 Foot)

Category: PLC Connection Cables

1492-P Push-in Terminal Blocks , 1.5 mm² ( AWG 26 - AWG 14) , 13 A , Control Power Distribution Block , End Block ,3 Points Red, 3 Points Blue

Category: Pluggable Terminal Blocks

Terminal Block, 25 Amp, 600 Volt AC/DC, 2 Connections Point per Side, Yellow, 30 - 12 AWG, 2.5mm, 50 in a Package

Category: 5.2mm Feed Through & Ground Terminal Blocks

Breaker, Motor Protection, Connecting Module, 25 - 45 Amp, For 140M-C to 100-C09-C23, Mounted on 2 DIN Rails

Category: Manual Motor Protector Connecting Links

Controller, SMC-Flex, Solid State, Open, 84 - 435 Amp, 75 - 350 Horse Power @ 200 - 480 Volt AC, 100 - 240 Volt AC Coil, Internal Bypass

Category: Basic Control Softstarters

Terminal Block Accessory, Center Jumper, IEC, Red, 3-Pole, For use with 4 mm Terminal Blocks

Category: Terminal Block Jumper Bars

Series 9000 GP Sensor, Timing, Std Retroreflective, AC/DC - MOSFET, 4 Pin DC MiniQD

Category: High Performance Photoelectric Sensor Logic Modules

I/O Module, Flex I/O, 4 Isolated, Analog Inputs, 80 mA, 24 Volt DC, Extended Temperature Range

Category: PLC I/O Modules